Honda CR125 Motocross Bike 2003
Reluctantly selling my 2003 CR125 Bought from TRM at Holbeach in May 2013.Top end done in April 2014 using genuine Honda parts, I have the receipt. Bike has done approx 8 hours since then mostly racing with Banovallum MCC and a few practice days. Has FMF Fatty pipe and Powercore 2 silencerRenthal RC High bend bars fitted as I am pretty tall (6ft4)Bike has been run on Putolene MX5 @ 40:1 mix as recommended by TRM It will come with a 48t rear sprocket as the last few places I rode were wide open courses. Might be a good idea to put a 52t or a 50t sprocket on for MX. Now the bike is 11 years old and in good condition for its age BUT there are a few niggles with it that I should make you aware of... The rear shock shaft has a small knick in it. I had to replace the seal around the same time as I did the top end and that's when I noticed it. I have clean it up as best as I can but I think it will eventually cut the new seal as wellWhilst greasing and checking the swingarm linkage I noticed that sometime in the bikes life the chain had gone through the slider behind the countershaft sprocket and eaten into the swingarm. Its not too deep and hasn't gone through to the bearing housings. The left hand radiator has been dented on its side which means that the plastic guard doesn't quite sit right but there are no leaks and it appears to be working fine.There is a bit of up and down play in the linkage which I think is coming from the top shock bearing.There is a small dent on the downp...